Internationaltruckenginecorporation

September 24, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: CERTAIN HEAVY DUTY TRUCKS FAIL TO COMPLY WITH REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS.

September 10, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE STEERING SHAFTS MAY HAVE A DEFECTIVE OR MIS-LOCATED WELD THAT COULD FAIL.

August 2, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: IN BELOW FREEZING OPERATING CONDITIONS, THE AIR-PRESSURE ACTUATED BRAKE LIGHT SWITCH THAT IS MOUNTED OUTSIDE THE CAB ON THE FRONT COWL, ON CERTAIN HEAVY DUTY TRUCKS, MAY NOT ACTIVATE DURING LIGHT TO NORMAL BRAKING. United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS/DRAG LINKS. THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.

June 26, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THERE IS AN ELECTRICAL PROBLEM WITH A REMOTE POWER MODULE.

June 7, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY 6X4 TRUCKS EQUIPPED WITH CHALMERS 800 SERIES SUSPENSION KITS. THESE SUSPENSION KITS MAY HAVE INSUFFICIENT PENETRATION OF THE WELD ATTACHING THE TORQUE ROD EYE TO THE TORQUE ROD TUBE. United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY VEHICLES EQUIPPED WITH A 20,000 POUND RATED DANA I-200 FRONT STEER AXLES. THERE ARE VISIBLE CRACKS IN THE SEAL DIAMETER AND LARGE BEARING DIAMETER ON THE FRONT AXLE KNUCKLES, WHICH CAN REDUCE THE LIFE EXPECTANCY OF THE KNUCKLES.

March 26, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH BOSTROM DRIVER SEAT MODELS (910, 910SC, OR 914) AND INTERNATIONAL'S PARKING BRAKE CODE 04036. IF SOMEONE OUTSIDE THE CAB ADJUSTS/SLIDES THE DRIVER'S SEAT TO ITS MOST FORWARD POSITION, WITH THE PARKING BRAKE SET, THE SEAT WILL CONTACT AND RELEASE THE PARKING BRAKE…

March 19, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.

February 1, 2001

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AIR BRAKE HALDEX AUTOMATIC SLACK ADJUSTERS, LONG STROKE BRAKE CHAMBERS, AND DANA BRAKES. THE AUTOMATIC SLACK ADJUSTER ANCHOR BRACKETS CAN FAIL DUE TO FATIGUE FRACTURE AND COMPLETELY SEPARATE, CAUSING THE SLACK ADJUSTERS TO FUNCTION AS MANUAL SLACK ADJUSTERS. United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: STRIPPED CHASSIS AND COMMERCIAL BUSES AND SCHOOL BUSES EQUIPPED WITH HYDRAULIC BRAKES AND AUTOMATIC TRANSMISSIONS. THE MISALIGNMENT OF THE BRAKE PEDAL CAN CAUSE DELAYED BRAKE LIGHT ACTIVATION DURING LIGHT BRAKING APPLICATIONS.

December 6, 2000

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE VEHICLES INVOLVED IN THIS RECALL WERE BUILT FOR EXPORT WITH MANUAL SLACK ADJUSTERS AND WERE SOLD IN THE US.

October 16, 2000

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: SCHOOL AND HEAVY DUTY TRUCKS EQUIPPED WITH TRW DRAG LINKS. EACH DRAG LINK ASSEMBLY CONTAINS TWO 20-EDL MODEL BALL SOCKET ASSEMBLIES.

September 26, 2000

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: TRUCKS EQUIPPED WITH ALLISON 1000 OR 2400 SERIES TRANSMISSIONS. THESE TRANSMISSIONS CAN EXPERIENCE PARK PAWL TO REAR COVER INTERFERENCE DUE TO AN OUT OF FLATNESS CONDITION.

August 21, 2000

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: TRACTORS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF… United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: MEDIUM AND HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A… United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: TRANSIT BUSES BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE… United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: SCHOOL BUSES BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF…

August 1, 2000

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE BRAKE LIGHT SWITCH AND THE CRUISE CONTROL SWITCH ARE MOUNTED IN SUCH A WAY AS TO ALLOW MOISTURE WITHIN THE AIR BRAKE SYSTEM TO COLLECT INSIDE THE SWITCHES.

July 3, 2000

United States

INTERNATIONAL TRUCK & ENGINE CORPORATION

VEHICLE DESCRIPTION: SCHOOL AND HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS. THE ABS SENSOR WIRES ON ROTATING PARTS CHAFES WHICH CAN LEAD TO A FALSE SIGNAL BEING SENT TO THE BENDIX ABS ELECTRONIC CONTROL UNIT (ECU).