RECALLS
32980 official campaigns
Safety recalls for cars and light vehicles, collected from NHTSA in the United States, EU Safety Gate, and the UK DVSA file.
32980 campaigns
United States
United States
Mack Trucks, Inc.
ON THE INVOLVED VEHICLES THE FLOORBOARD OPENING AND THE STEERING COLUMN SEAL BRACKET DO NOT HAVE SUFFICIENT CLEARANCE TO ALLOW THE SHAFT TO TURN FREELY. THIS CAUSES THE PINCH BOLT TO BIND OR LOCK AGAINST THE SEAL BRACKET.
United States
Ford Motor Company
COOLING FAN BLADES MAY CRACK AND SEPARATE BECAUSE THEY CANNOT WITHSTAND STRESS FROM VIBRATIONS THAT OCCUR DURING NORMAL ENGINE OPERATION.
United States
United States
United States
General Motors, LLC
VEHICLES MAY HAVE BEEN ASSEMBLED WITHOUT THE ROOF MARKER LAMPS REQUIRED FOR TRUCKS OF 80 OR MORE INCHES OVERALL WIDTH. VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 108, "LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT".
United States
Ford Motor Company
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH LEFT REAR BRAKE ASSEMBLIES THAT WERE INCORRECTLY PRODUCED AND MAY HAVE ONE OR TWO AUTOMATIC BRAKE ADJUSTERS THAT WERE INTENDED FOR RIGHT REAR BRAKE ASSEMBLIES. THE ADJUSTER WORKS BACKWARDS AND INCREASES THE CLEARANCE BETWEEN THE BRAKE LINING AND DRUM, INSTEAD OF…
United States
Ford Motor Company
SOME OF THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH IMPROPERLY HEAT TREATED FRONT SUSPENSION LOWER SPRING SEAT ATTACHING STUDS. THESE STUDS COULD FRACTURE DURING VEHICLE OPERATION, ALLOWING THE LOWER SPRING SEAT TO MOVE AND POSSIBLY SLIDE OFF THE AXLE.
United States
HOLIDAY RAMBLER CORP.
THE FUEL SWITCH ON THE DUAL FUEL CONTROL HAS BEEN WIRED INCORRECTLY. THE SWITCH WAS WIRED IN SUCH A WAY THAT THE DRIVER COULD BE PUMPING PROPANE TO THE CARBURETOR. United StatesWHITE MOTOR CORPORATION
IN CERTAIN TYPES OF COLLISIONS, THE DOOR LATCHES MAY RELEASE AND THE DOOR COULD OPEN. THE DOOR LATCH SYSTEM FAILS TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 206, "DOOR LOCKS AND DOOR RETENTION COMPONENTS".
United States
Ford Motor Company
THE FLEXIBLE BLADE ENGINE COOLING FAN BLADES MAY CRACK AND BREAK OFF. THIS MAY BE CAUSED BY HIGH BLADE STRESSES THAT CAN RESULT FROM VIBRATION DURING VEHICLE OPERATION. United StatesPACCAR Incorporated
FRONT AXLE AIR BRAKE CHAMBER IS ATTACHED WITH A CLAMP AND BOLT ASSEMBLY THAT MAY NOT HAVE BEEN POSITIONED CORRECTLY, AND MAY CHAFE AGAINST THE FRONT BRAKE HOSE. CHAFING COULD RESULT IN AN AIR LEAK AND LOSS OF AIR TO THE FRONT BRAKES. United StatesPACCAR Incorporated
THE U SHAPED BOLTS THAT CONNECT THE SPRINGS AND SPRING SPACERS TO THE FRONT AXLE MAY NOT HAVE BEEN INSTALLED PROPERLY. THIS CONDITION COULD ALLOW THE AXLE TO SHIFT AND COULD DEGRADE THE STEERING CHARACTERISTICS OF THE VEHICLE. United StatesPACCAR Incorporated
STEERING COMPONENTS MAY INTERFERE WITH EACH OTHER AND COULD LEAD TO SEPARATION OF STEERING LINKAGE. THE DRAGLINK, A COMPONENT IN THE STEERING LINKAGE THAT TRANSMITS TURNING MOVEMENTS TO THE WHEELS, MAY HAVE A CLAMP ON THE AXLE END WHICH HAS BEEN INCORRECTLY POSITIONED ON THE INBOARD SIDE OF THE DRAGLINK. United StatesPACCAR Incorporated
THE REAR BRAKES MAY NOT RELEASE AS QUICKLY AS SPECIFICATIONS REQUIRE. CERTAIN TRUCKS WERE EQUIPPED WITH AN INCORRECT SIZE AIR BRAKE LINE INSTALLED BETWEEN THE REAR BRAKE RELAY VALVE AND THE AXLE TEE FITTING.
United States
Ford Motor Company
THE MANUFACTURER SUSPECTS THAT THE HARDWARE THAT ATTACHES THE SEAT TRACKS (THE STRIPS THAT THE SEAT SLIDES ON) TO THE FLOOR MAY BECOME LOOSE OR MAY FAIL TO HOLD THE SEAT IN PLACE DURING A COLLISION. THIS CONDITION IS DUE TO THE SUBSTITUTION OF AN INCORRECT WASHER DURING MANUFACTURE.
United States