Internationalllc

December 21, 2006

United States

International Motors, LLC

ON CERTAIN TRUCKS, THE A-PILLAR MOUNTED ENTRY/EGRESS GRAB HANDLE MAY LOOSEN AND POSSIBLY SEPARATE FROM THE VEHICLE. United States

International Motors, LLC

CERTAIN IC SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN OCTOBER 11, 2005, AND OCTOBER 31, 2006. THESE BUSES HAVE THE FOLLOWING SAFETY ISSUES: IF THE DRIVER'S SEAT IS IN THE HIGHEST AND MOST REAR POSITION, THE BACK OF THE SEAT MAY LEAN AGAINST A BARRIER BEHIND THE SEAT, OR AGAINST THE SEAT BACK.

October 25, 2006

United States

International Motors, LLC

CERTAIN MY 2003 THROUGH 2007 IC CESB AND MY 1998 3800 SCHOOL BUSES MANUFACTURED BETWEEN DECEMBER 23, 1997, AND MARCH 31, 2006. THE HANDRAILS WERE NOT INSTALLED CORRECTLY WHICH WILL ALLOW PASSENGER COAT STRINGS OR DRAWSTRINGS TO GET CAUGHT AS THE PASSENGER EXITS THE BUS.

October 11, 2006

United States

International Motors, LLC

ON CERTAIN TRUCKS EQUIPPED WITH CHALMERS REAR SUSPENSIONS, THE ADJUSTABLE TORQUE ROD END CASTINGS MAY BE BRITTLE. A BRITTLE ROD END CASTING MAY FRACTURE WITHOUT WARNING, CAUSING THE VEHICLES' REAR AXLES TO BECOME MISALIGNED.

October 3, 2006

United States

International Motors, LLC

ON CERTAIN TRUCKS EQUIPPED WITH VT-275 ENGINES, THE ELECTRICAL CONNECTOR OF THE INJECTION PRESSURE REGULATOR (IPR) VALVE ON THE ENGINE CAN FILL WITH RAIN WATER AND ROAD DEBRIS, POSSIBLY CAUSING TERMINAL CORROSION THAT MAY LEAD TO ELECTRICAL VOLTAGE DROPS.

July 27, 2006

United States

International Motors, LLC

CERTAIN MY 2006 AND 2007 IC CE AND 2007 BE SCHOOL BUSES MANUFACTURED BETWEEN AUGUST 3, 2005, AND MAY 1, 2006. THE CONFIGURATION OF THE MOUNTING BRACKET FOR THE 39 INCH TRACK MOUNTED CE WHITE CHILD SAFETY SEAT FAILS TO CONFORM TO THE STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.

June 28, 2006

United States

International Motors, LLC

ON CERTAIN TRUCKS EQUIPPED WITH SR-7 BENDIX BRAKE VALVES, THE CHECK VALVE INSIDE THE VALVE CAVITY MAY NOT PROPERLY SET, CAUSING INTERNAL AIR LEAKAGE. IF THE CHECK VALVE DOES NOT PROPERLY SEAT, THE RESULTING LEAKAGE CAN CAUSE A DELAY IN THE APPLICATION OF THE SPRING BRAKES TO PARK THE VEHICLE AFTER OPERATOR PULLS THE…

June 23, 2006

United States

International Motors, LLC

CERTAIN 2006 AND 2007 IC RESB (PB305) SCHOOL BUSES MANUFACTURED BETWEEN JULY 1, 2005, AND MAY 9, 2006. A JOINT AT THE REAR OF THE BUS WHERE THE DAVENPORT IS ATTACHED TO THE FLOOR DOES NOT MEET THE JOINT STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.

June 2, 2006

United States

International Motors, LLC

CERTAIN MY 2004 THROUGH 2007 CE AND BE SCHOOL BUSES AND 1300 AND 3300 MODEL VEHICLE CHASSIS MANUFACTURED BY IC CORPORATION BETWEEN MARCH 17, 2004, AND MAY 15, 2006. THE PARK BRAKE SYSTEM MAY ACTIVATE WHILE THE VEHICLE IS UNDER NORMAL OPERATION.

April 25, 2006

United States

International Motors, LLC

CERTAIN MY 2006 AND 2007 IC CORPORATION FE, RE, AND IC SCHOOL BUSES AND CE SCHOOL AND COMMERCIAL BUSES MANUFACTURED BETWEEN JUNE 12, 2005, AND MARCH 29, 2006, AND EQUIPPED WITH RICON 1200, 2000, AND 5500 SERIES WHEELCHAIR LIFTS. THE PLATFORM LIFTS MAY HAVE A DEFECT IN THE WELD WHICH WILL ALLOW A JOINT ON THE VERTICAL…

March 17, 2006

United States

International Motors, LLC

ON CERTAIN TRUCKS, THE HOSE CONNECTING THE ENGINE BLOCK TO THE FRAME IS ROUTED NEAR THE ENGINE'S TURBOCHARGER. HEAT FROM THE TURBOCHARGER MAY CAUSE THE HOSE TO MELT.

January 10, 2006

United States

International Motors, LLC

ON CERTAIN TRUCKS EQUIPPED WITH CATERPILLAR DIESEL ENGINES, THE VARIABLE VALVE ACTUATION (VVA) OIL LINE MAY WEAR AGAINST THE SHARP EDGE OF THE CYLINDER HEAD IF NOT POSITIONED CORRECTLY.

December 21, 2005

United States

International Motors, LLC

CERTAIN TRUCKS BUILT WITH A 8X6 WHEEL CONFIGURATION (TRIDEMS) FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, 'AIR BRAKE SYSTEMS. United States

International Motors, LLC

ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR DIESEL ENGINES, THE ENGINE ELECTRICAL GROUND CABLE THAT CONNECTS THE ENGINE BLOCK WITH THE STARTER MAY BE ROUTED IN A WAY THAT COULD CAUSE CHAFING AGAINST THE STARTER'S POSITIVE BATTERY CABLES.

November 16, 2005

United States

International Motors, LLC

ON CERTAIN TRUCKS, THE CAB ENTRY STEPS WERE MANUFACTURED INCORRECTLY CAUSING THEM TO HAVE LOWER MATERIAL STRENGTH PROPERTIES THAN DESIGNED. THESE LOWER MATERIAL STRENGTH PROPERTIES CAN ALLOW THE STEP TREAD TO FRACTURE AND SEPARATE FROM THE VEHICLE UNDER NORMAL USAGE.

October 4, 2005

United States

International Motors, LLC

ON CERTAIN HEAVY DUTY TRUCK/TRACTORS EQUIPPED WITH ARVINMERITOR SERIES 145 AND 160 REAR DRIVE AXLES. THE SUSPECT REAR DRIVE AXLE'S SPINDLES MAY HAVE BEEN INCORRECTLY HEAT TREATED. United States

International Motors, LLC

ON CERTAIN HEAVY DUTY TRUCK/TRACTORS EQUIPPED WITH SEARS ATLAS SERIES 35, 70, OR 80 DRIVER'S SEATS, WHEN THE SEATS ARE IN THEIR LOWEST, MOST REARWARD ADJUSTED POSITION, THEY MAY CHAFE THE SEAT BELT TETHER THAT CONNECTS FROM THE SEAT TO THE BACK OF THE CAB.

August 26, 2005

United States

International Motors, LLC

CERTAIN MY 2005 THROUGH 2006 INTERNATIONAL HEAVY TRUCKS AND IC CORP CE SCHOOL BUSES MANUFACTURED BETWEEN JUNE 4, 2004, AND MARCH 31, 2005. THE ANCHOR BOLT THAT IS THE PIVOT POINT FOR THE DRIVELINE PARKING BRAKE SHOES MAY FATIGUE AND BREAK AS A RESULT OF AN INCORRECT SURFACE TREATMENT.

July 26, 2005

United States

International Motors, LLC

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY.

July 20, 2005

United States

International Motors, LLC

CERTAIN IC MY 2002 THROUGH 2004 3800; 2002 THROUGH 2006 CESB, FESB, AND RESB; AND 2006 AND 2007 BESB SCHOOL BUSES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: ALASKA, COLORADO, CONNECTICUT, DELAWARE, IDAHO, ILLINOIS, INDIANA, IOWA, KANSAS, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN…