RECALLS

December 2, 1992

United States

BMW of North America, LLC

THE 80-AMPERE FUSIBLE LINK LOCATED IN THE ENGINE COMPARTMENT CAN DEVELOP MECHANICAL WEAKNESS DUE TO AGING AND THERMAL STRESSES, AND CAN BREAK. United States

Subaru of America, Inc.

THE INNER ARMS OF THE REAR SUSPENSION ARE SUBJECT TO CORROSION IN AREAS WHERE ROAD SALT IS USED HEAVILY IN WINTER. United States

Nissan North America, Inc.

FUEL FILLER HOSES MAY HAVE BEEN CUT PRIOR TO INSTALLATION BY A UTILITY KNIFE USED TO OPEN THE SHIPPING BOX. United States

Ford Motor Company

FUEL FILLER HOSES MAY HAVE BEEN CUT PRIOR TO INSTALLATION BY A UTILITY KNIFE USED TO OPEN THE SHIPPING BOX.

November 30, 1992

United States

Harley-Davidson Motor Company

THE FUEL INLET NEEDLE DOES NOT SEAL PROPERLY AGAINST THE FUEL INLET SEAT.

November 24, 1992

United States

Oshkosh Corporation

THE STAINLESS STEEL FASTENERS FOR THE CAB ENTRY STEPS AND GRAB HANDLES CAN CRACK AND BREAK.

November 18, 1992

United States

Ford Motor Company

THE LINK LEVER TRUNION ON THE SAFETY BELT RETRACTOR MAY HAVE BEEN DAMAGED DURING INSTALLATION.

November 17, 1992

United States

COLEMAN CO., INC.

THE WHEEL WELL WAS NOT RECESSED DEEPLY ENOUGH TO ALLOW ADEQUATE CLEARANCE BETWEEN THE TIRE SIDEWALL AND WHEEL WELL.

November 12, 1992

United States

AMERTEK, ININC.

A CONTAMINANT FROM IMPURITIES IN THE HYDRAULIC RETURN HOSES OR THE OIL RESERVOIR CAN LEAD TO MALFUNCTIONS OF THE PRESSURE CONTROL VALVES CONTROLLING THE POWER STEERING AND WATER PUMP ENGAGEMENT. United States

Harley-Davidson Motor Company

SCREWS (PART NUMBER 3655) USED TO MOUNT THE FRONT WHEEL BRAKE DISC, THE JIFFY STAND SPRING, AND FRONT WHEEL CAP, DO NOT MEET HARLEY- DAVIDSON'S STRENGTH REQUIREMENTS AND MAY BREAK DURING VEHICLE OPERATION. United States

Winnebago Industries, Inc.

THE TAIL LIGHT LENSES DO NOT HAVE A REFLECTIVE SURFACE. United States

AMERTEK, ININC.

THE FRONT WHEEL DISC CRACKS AROUND THE BOLT HOLE CIRCLE.

November 10, 1992

United States

Ford Motor Company

November 8, 1992

United States

General Motors, LLC

THE POWER STEERING GEAR INLET HOSE ON THESE VEHICLES CAN FRACTURE, CAUSING POWER STEERING FLUID TO SPRAY FROM HOSE INTO THE ENGINE COMPARTMENT.

November 4, 1992

United States

FRUEHAUF CORPORATION

THE INNER WHEEL BEARING CONES WERE MISSING FROM THE WHEEL ASSEMBLIES. MISSING INNER BEARING CONES CAN CAUSE OIL SEAL DETERIORATION OR CAUSE OVERHEATED BRAKES BECAUSE THE BRAKE DRUM COULD REST ON THE BRAKE LINING.

November 3, 1992

United States

Jayco, Inc.

THE STOP/TURN COMBINATION MODULE OF THE REAR LIGHT ASSEMBLY WAS INSTALLED AS A SINGLE FILAMENT LAMP DEVICE WHICH ONLY FUNCTIONS AS A STOP/TURN LAMP, AND DOES NOT PROVIDE TAIL LAMPS. United States

General Motors, LLC

THERE IS FUEL LEAKAGE AT THE FUEL TANK FILL AND/OR VENT PIPE EXTENSION SOLDER JOINTS. United States

Mazda North American Operations

A HARDTOP HOIST ACCESSORY KIT WAS SOLD TO CUSTOMERS WHO HAVE THE MIATA WITH A HARDTOP. THE PLASTIC BUCKLES USED TO ADJUST STRAP TENSION CAN BREAK AFTER THE HARDTOP HAS BEEN SUSPENDED BY THE HOIST. United States

GRUMMAN CORP.

THE HEATER HOSE ROUTING CAN INTERFERE WITH THE THROTTLE CONTROL SYSTEM.

November 2, 1992

United States

Erwin Hymer Group North America, Inc.

1) THE SEAT SYSTEM SLIDE TRACKS DO NOT ALLOW THE SEATS TO SLIDE, AND THERE IS AN INCORRECT ANGLE OF THE UPPER TORSO SAFETY BELT CAUSED BY NON-CHRYSLER HARDWARE AT THE SHOULDER SAFETY BELT ANCHORAGES.