SEARCH

Popular Searches:

Skoda Enyaq Giulia QV Golf GTI Bravo T-Jet SUV Reviews Electric Cars Opel Astra 2026 BMW M3 Toyota Corolla Fiat Freemont

Nissan

571 campaigns

United States
European Union
United Kingdom

Safety recalls for Nissan.

571 campaigns

April 22, 1997

Nissan North America, Inc.

VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND…

Nissan North America, Inc.

THE RELEASE BUTTON USED IN THE REAR SEAT BELT BUCKLES WERE NOT MADE ACCORDING TO SPECIFICATIONS. IN HOT WEATHER, THE PLASTIC WELDS SECURING THE RELEASE BUTTON TO THE SPRING CAN FAIL RESULTING IN PARTIAL ENGAGEMENT OF THE SEAT BELT TONGUE IN THE BUCKLE OR NOT BEING ABLE TO LATCH THE SEAT BELT.

October 10, 1996

Nissan North America, Inc.

CERTAIN BUCKLE ASSEMBLIES WERE PRODUCED WITH A "BUCKLE BASE" THAT WAS IMPROPERLY HEAT TREATED. THIS CAN CAUSE THE "BUCKLE BASE" TO BE BRITTLE FAILING TO COMPLY TO FMVSS NO.

September 10, 1996

Nissan North America, Inc.

THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.

June 4, 1996

Nissan North America, Inc.

AN OUT-OF-SPECIFICATION CONDITION IN THE SEAT CABLE ROLLER PULLEY ASSEMBLY CAN ALLOW THE CABLE THAT CONNECTS THE SEAT ADJUST LEVER TO THE LATCH TO BE PINCHED IN THE ROLLER ASSEMBLY.

May 9, 1996

Nissan North America, Inc.

A HARNESS CONNECTOR PROTECTOR LOCATED NEAR THE SEAT BELT PRE-TENSIONER CAN IGNITE DUE TO THE PROXIMITY TO THE COMBUSTION GAS GENERATED BY THE PRE-TENSIONER WHEN THE DEVICE IS TRIGGERED.

February 22, 1996

Nissan North America, Inc.

DUE TO THE THICKNESS OF THE CARPET PADDING ON THE TRANSMISSION TUNNEL, THE SPACE BETWEEN THE BRAKE PEDAL AND THE TRANSMISSION TUNNEL COULD CATCH A DRIVER'S RIGHT FOOT UNDER THE BRAKE PEDAL.

Nissan North America, Inc.

DUE TO THE TYPE OF LUBRICANT USED IN THE STEERING TRANSFER GEAR ASSEMBLY, THE EFFORT REQUIRED TO TURN THE STEERING WHEEL AT LOW AMBIENT TEMPERATURES (LESS THAN -30 C) COULD INCREASE TO THE POINT WHERE SOME DRIVERS WOULD HAVE DIFFICULTY IN TURNING THE WHEEL.

December 15, 1995

Nissan North America, Inc.

IT IS POSSIBLE FOR A MIXTURE OF MUD AND SALT TO GET TRAPPED BETWEEN THE FUEL FILLER TUBE AND WHEEL HOUSING. THE TRAPPED MUD AND SALT CAN RESULT IN CORROSION OF THE FUEL FILLER TUBE AND THE WHEEL HOUSING.

November 22, 1995

Nissan North America, Inc.

LEAVES AND OTHER FOREIGN MATERIAL CAN ENTER THROUGH THE COWL PANEL AIR INTAKE DURING OPERATION OF THE FRONT HEATER AND/OR AIR CONDITIONING SYSTEM RESULTING IN A BUILD-UP OF MATERIAL IN THE PLENUM. THIS CAN LEAD TO NOISE, ODORS, OR IN SOME CASES, IGNITION OF THESE MATERIALS.

November 1, 1995

Nissan North America, Inc.

THIS IS NOT A SAFETY RECALL CAMPAIGN IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY.

May 24, 1995

Nissan North America, Inc.

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS.

March 1, 1995

Nissan North America, Inc.

THE ANTI-LOCK BRAKING SYSTEM (ABS) HYDRAULIC ACTUATOR WAS NOT PROPERLY PURGED OF ALL AIR DURING THE FILL AND EVACUATION PROCESS CAUSING AIR BUBBLES TO GET INTO THE BRAKE SYSTEM.

January 24, 1995

Nissan North America, Inc.

CERTAIN OF THE BRAKE HOSES FOR THE RIGHT REAR WHEEL WERE ROUTED INCORRECTLY SO THAT CONTACT IS MADE WITH A SUSPENSION COMPONENT. THIS CAUSES ABRASION TO THE HOSE AND EVENTUAL LEAKAGE.

December 30, 1994

Nissan North America, Inc.

THE RIGHT FRONT BRAKE CALIPER PISTON SEAL GROOVE WAS IMPROPERLY MACHINED CAUSING A BRAKE FLUID LEAK WHEN THE BRAKES ARE APPLIED.

December 14, 1994

Nissan North America, Inc.

TRUCKS WERE ASSEMBLED WITHOUT A DOOR LOCK PLATE IN THE RIGHT SIDE DOOR.

October 5, 1994

Nissan North America, Inc.

THE ALUMINUM WHEELS WERE CLEAR COATED SEVERAL TIMES TO PROTECT THE METAL FINISH. SOME EXCESSIVE COATING CAN LEAVE THE WHEEL NUTS AN EXCESSIVE DISTANCE FROM THE WHEEL HUB WHEN TIGHTENED, ALLOWING THEM TO LOOSEN OVER TIME.

September 2, 1994

Nissan North America, Inc.

THE SHIFT LEVER LOCK PLATE, WHICH PREVENTS THE SHIFT LEVER FROM BEING INADVERTENTLY MOVED FROM PARK TO DRIVE OR NEUTRAL POSITION, CAN BE BROKEN BY THE TRANSMISSION SHIFT POSITION PIN.

July 25, 1994

Nissan North America, Inc.

THE INSTRUMENT PANEL BRAKE WARNING LIGHT WILL NOT ILLUMINATE WHEN THE BRAKE FLUID LEVEL IN THE MASTER CYLINDER DROPS SUFFICIENTLY TO ACTIVATE THE LOW LEVEL SWITCH DUE TO AN IMPROPERLY WIRED DIODE, REQUIRED BY FMVSS NO. 105, "HYDRAULIC BRAKE SYSTEMS.

February 28, 1994

Nissan North America, Inc.

ENGINE MOVEMENT CAN BE TRANSMITTED TO THE AIRFLOW METER/FILTER HOUSING AND SUPPORT BRACKET, WHICH IS MOUNTED IN THE ENGINE AIR DUCT, CAUSING THE THROTTLE CABLE HOUSING TO PULL OUT OF THE CABLE GUIDE. THIS MAY PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION WHEN THE GAS PEDAL IS RELEASED.