Honda

September 18, 2000

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MOTORCYCLES. AN IMPROPER SERVICE PROCEDURE THAT MAY BE USED DURING ROUTINE MAINTENANCE CAN DAMAGE A PRESSURIZED FUEL HOSE.

July 14, 2000

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR SUSPENSION LOWER ARMS AND/OR CONTROL ARMS COULD BREAK DUE TO IMPROPER WELDING.

July 6, 2000

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINI VANS. THE DIMMER CONTROL FOR THE INSTRUMENT PANEL LIGHTS CAN FAIL.

April 25, 2000

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINIVAN. THE SLIDING DOORS MAY NOT LATCH PROPERLY.

February 11, 2000

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINI VANS. A WIRE HARNESS, LOCATED WITHIN THE ENGINE COMPARTMENT, COULD BE DAMAGED BY CONTACT WITH A METAL PIPE, POSSIBLY RESULTING IN A BLOWN FUSE.

January 24, 2000

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: CONVERTIBLE PASSENGER VEHICLES. WHEN THE CONVERTIBLE TOP IS DOWN AND THE SEAT IS PUSHED ALL THE WAY BACK, THE SEAT BELTS MAY NOT RETRACT PROPERLY RESULTING IN SLACK IN THE SEAT BELTS.

December 15, 1999

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINIVANS. THE FRONT BODY/FRAME IS MISSING SPOT WELDS.

October 19, 1999

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. AN IMPROPERLY ROUTED UNDER DASH WIRE HARNESS COULD BE DAMAGED BY CONTACT WITH THE BRAKE LIGHT SWITCH, POSSIBLY RESULTING IN A BLOWN FUSE.

August 19, 1999

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. A TRANSMISSION CASE BOLT CAN LOOSEN AND FALL OUT ALLOWING THE TRANSMISSION TO DISENGAGE FROM THE DIFFERENTIAL.

June 24, 1999

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINIVAN. THE SLIDING DOORS MAY NOT LATCH PROPERLY. United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINIVAN. THE POWER DOOR LOCK REMOTE CONTROL ACTUATOR UNLATCHES THE DOOR IN RESPONSE TO INPUT FROM THE REMOTE TRANSMITTER. United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MINIVAN. IN EXTREMELY COLD, WET WEATHER, ICE CAN FORM IN THE THROTTLE BODY PREVENTING THE THROTTLE RETURN TO THE IDLE POSITION.

May 24, 1999

United States

Honda (American Honda Motor Co.)

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY.

May 10, 1999

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. CERTAIN VEHICLES WERE MANUFACTURED WITH BALL JOINTS THAT CAN PREMATURELY WEAR OUT AND, IN THE WORSE CASE, THE BALL JOINT WOULD SEPARATE CAUSING THE FRONT SUSPENSION TO COLLAPSE.

December 8, 1998

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: ELECTRIC VEHICLES. THE PROGRAM LOGIC FOR THE MOTOR ELECTRONIC CONTROL UNIT (ECU) CAN MISTAKENLY DETECT A FAILURE OF AN ELECTRICAL CURRENT SENSOR AT SPEEDS ABOVE 50 MPH.

September 22, 1998

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: SEDAN, COUPE AND WAGON PASSENGER VEHICLES EXCEPT THE DX MODEL AND MODELS WITH V6 ENGINES. THE FACTORY INSTALLED AIR CONDITIONER WIRE HARNESS WAS IMPROPERLY ROUTED ALLOWING SOME WIRES TO RUB AGAINST EACH OTHER, EVENTUALLY CAUSING A SHORT CIRCUIT.

July 24, 1998

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. A GROUND CONNECTION TERMINAL WAS NOT PROPERLY CRIMPED IN THE SUPPLIER'S ENGINE WIRING HARNESS MANUFACTURING LINE.

February 10, 1998

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: PASSENGER VEHICLES (HONDA ACCORD SEDANS MANUFACTURED FROM SEPTEMBER 18, 1997 TO JANUARY 10, 1998; COUPES MANUFACTURED DECEMBER 11, DECEMBER 15, 1997, AND JANUARY 5, 1998; ACURA 2. 3CL MANUFACTURED OCTOBER 22, 1997 THROUGH JANUARY 7, 1998).

December 16, 1997

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FRONT PASSENGER SEAT BELT RETRACTOR MOUNTING BRACKET WAS IMPROPERLY WELDED.

November 13, 1997

United States

Honda (American Honda Motor Co.)

VEHICLE DESCRIPTION: MULTI-PURPOSE PASSENGER VEHICLES EQUIPPED WITH A DRIVER'S SIDE OPTIONAL EQUIPMENT RUBBER FLOOR MAT. REPEATED MOVEMENT OF THE DRIVER'S FEET AND ACTUATION OF THE ACCELERATOR PEDAL CAN RESULT IN A SHIFTING OF THE MAT'S POSITION.