Brands Cars Engines Gearboxes Platforms

SEARCH

Hendricksonmfg

6 campaigns
  • United States
  • European Union
  • United Kingdom

Safety recalls for Hendricksonmfg.

6 campaigns

United States

HENDRICKSON MFG. CO.

THE BOLTS THAT CLAMP THE MOR/RYDE SUSPENSION BEAM AND LOWER MOUNTING PLATE TO THE AXLE MAY BREAK AS A RESULT OF MISALIGNMENT OF THE BOLTS DUE TO NON-PARALLEL SURFACES OF THE UPPER BEAM PLATE AND THE LOWER BOTTOM PLATE. ANOTHER CONTRIBUTING FACTOR IS THE ABSENCE OF SHEAR BLOCKS TO THE UPPER SPACER PAD.
United States

HENDRICKSON MFG. CO.

THE LOW AIR PRESSURE SWITCHES USED ON SOME OF THE INVOLVED VEHICLES HAVE A MANUFACTURING TOLERANCE THAT ISSUES A WARNING ONLY WHEN THE PRESSURE DROPS A FEW POUNDS PER SQUARE INCH BELOW 60 PSI. AS A RESULT, THEY DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.
United States

HENDRICKSON MFG. CO.

THE BRAKE SHOE WELDS ON THE REAR BRAKE ASSEMBLIES COULD FAIL AT THE POINT WHERE THE WELD JOINS THE BRAKE SHOE TABLE. A BROKEN WELD COULD RESULT IN LOSS OF BRAKING CAPABILITY.
United States

HENDRICKSON MFG. CO.

THE INVOLVED VEHICLES WERE MANUFACTURED USING A STANDARD TYPE NUT TO FASTEN THE STEERING WHEEL TO THE STEERING COLUMN. THIS NUT MAY NOT HAVE BEEN TIGHTENED TO SPECIFICATIONS AND MAY BACK OFF THE STEERING COLUMN AS A RESULT.
United States

HENDRICKSON MFG. CO.
United States

HENDRICKSON MFG. CO.