General

July 31, 1996

United States

General Motors, LLC

THESE VEHICLES EXHIBIT A CONDITION IN WHICH A REAR SEAT BELT BUCKLE RELEASE BUTTON CAN STICK IN THE UNLATCHED (DOWN) POSITION UNDER CERTAIN CONDITIONS BECAUSE THE BUCKLE ASSEMBLY CAN MOVE INSIDE THE SEAT BELT COVER. IF THE COVER MOVES FAR ENOUGH, IT CAN CREATE AN INTERFERENCE CONDITION WITH THE LATCH RELEASE BUTTON.

July 1, 1996

United States

General Motors, LLC

THESE VEHICLES WERE ASSEMBLED WITH ONE OF THE FOUR BRAKE BOOSTER TABS NOT PROPERLY LOCATED IN THE FRONT OF DASH REINFORCEMENT ASSEMBLY. United States

General Motors, LLC

THE FUEL TANK ON THESE VEHICLES CAN BECOME PUNCTURED BY A FUEL TANK FLANGE ATTACHMENT REINFORCEMENT DURING REAR-END COLLISIONS. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. United States

General Motors, LLC

THE AUTO-APPLY PARK BRAKE (MANUAL OR AUTO APPLICATION) DOES NOT ALWAYS APPLY. IF THE PARK BRAKE DOES NOT APPLY, THE "SERVICE PARK BRAKE" WARNING LIGHT WILL ILLUMINATE. United States

General Motors, LLC

A BACKFIRE DURING ENGINE STARTING CAN CAUSE BREAKAGE OF THE UPPER INTAKE MANIFOLD. United States

General Motors, LLC

THE STEERING WHEEL CENTER HUB TO SPOKE WELD CAN FRACTURE. United States

General Motors, LLC

THESE TIRES HAVE BEAD DAMAGE WHICH OCCURED DURING TIRE MOUNTING.

June 3, 1996

United States

General Motors, LLC

ONE OF THE FOUR REAR AXLE U-BOLTS CAN BREAK. THIS CAN POTENTIALLY LEAD TO THE SPRING LIFTING FROM THE AXLE UNDER CERTAIN REBOUND, BRAKING OR CORNERING MANEUVERS.

May 7, 1996

United States

General Motors, LLC

THE FOUR U-BOLTS NUTS ON EITHER SIDE OF THE REAR AXLE WERE UNDER-TORQUED.

April 30, 1996

United States

General Engines Company, Inc.

April 19, 1996

United States

General Motors, LLC

THE LEFT FRONT BRAKE LINE CAN CONTACT THE TRANSAXLE MOUNTING BRACKET OR ATTACHMENT BOLT.

April 4, 1996

United States

General Motors, LLC

THESE VEHICLES WERE ASSEMBLED WITH THE THROTTLE CABLE CONTACTING THE DASH MAT WHICH COULD BIND THE THROTTLE. THIS DOES NOT MEET WITH THE MAXIMUM RETURN TIMES REQUIRED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.

March 5, 1996

United States

General Motors, LLC

THESE VEHICLES WERE ASSEMBLED WITH ONE OR MORE INCORRECT SAFETY BELT AND/OR SAFETY BELT BUCKLE ENDS. THIS DOES NOT CONFORM WITH THE REQUIREMENTS OF FMVSS NO.

February 22, 1996

United States

General Motors, LLC

SOME OF THESE TRUCKS WERE BUILT WITH TRANSMISSIONS CONTAINING PARTS WHICH WERE NOT MACHINED TO GM'S SPECIFICATIONS.

February 12, 1996

United States

General Motors, LLC

SOME OF THE WELDS BETWEEN THE ROOF AND ROOF SIDE INTERNAL REINFORCEMENT PANELS DO NOT MEET THE MANUFACTURER'S SPECIFICATIONS.

January 31, 1996

United States

General Motors, LLC

THE REAR LOWER CONTROL ARM CAN CRACK AT THE REAR STABILIZER BAR ATTACHMENT.

January 30, 1996

United States

General Motors, LLC

DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN. United States

General Motors, LLC

DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN.

January 23, 1996

United States

General Motors, LLC

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. United States

General Motors, LLC

VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.