Ford
1958 campaigns
Safety recalls for Ford.
1958 campaigns
United States
Ford Motor Company
SOME OF THE INVOLVED VEHICLES MAY HAVE A DIODE IN THE ELECTRICAL FUEL PUMP CIRCUIT THAT MAY SHORT DURING ENGINE STARTING DUE TO INADEQUATE CAPACITY TO WITHSTAND CURRENT DRAW. A SHORT CIRCUIT WOULD RESULT IN NORMAL ENGINE STARTING, BUT THE PUMP WILL NOT CONTINUE TO SUPPLY THE ENGINE WITH FUEL.
United States
Ford Motor Company
FUEL SYSTEM ON THE SUSPECT VEHICLES MAY NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".
United States
Ford Motor Company
THE BRAKE MASTER CYLINDER TO CHASSIS TUBE AND HOSE ASSEMBLY MAY HAVE BEEN LOCATED IN SUCH A WAY THAT IT IS SUSCEPTIBLE TO CHAFING DURING VEHICLE OPERATION. CONTINUED CHAFING MAY RESULT IN TUBE OR HOSE FAILURE AND SUBSEQUENT LOSS OF BRAKE FLUID.
United States
Ford Motor Company
THESE VEHICLES MAY HAVE BEEN MANUFACTURED WITH AN INCORRECT END CLAMP ON THE HAND THROTTLE ACTUATING CABLE. UNDER CERTAIN CONDITIONS, PERTAINING TO THE CLAMP-TO-THROTTLE CABLE ORIENTATION AND DISTANCES OF THE CABLE TO GOVERNOR SHAFT, THE THROTTLE CABLE END CLAMP MAY INTERFERE WITH THE OUTBOARD ACCELERATOR.
United States
Ford Motor Company
THE SPRINGS THAT ASSIST IN RAISING THE HOOD MAY DETACH FROM THE HOOD WITHOUT WARNING. THE HOOD CAN BE IN ANY POSITION WHEN THIS OCCURS.
United States
Ford Motor Company
ON CERTAIN VEHICLES, THE LOCK WEDGES USED TO SECURE THE AXLE BEARING NUTS TO THE AXLE HOUSING MAY FALL OUT OF POSITION, ALLOWING THE NUT TO LOOSEN. THE NUT ON THE LEFT SIDE MAY FALL OFF, ALLOWING MOVEMENT OF THE AXLE SHAFT.
United States
Ford Motor Company
AN INCORRECT INSULATOR MAY HAVE BEEN INSTALLED IN THE STEERING SHIFT CANE LEVER ON THE INVOLVED VEHICLES. THIS INSULATOR IS USED TO CONNECT THE TRANSMISSION SHIFT LINKAGE TO THE SHIFT CANE LEVER.
United States
Ford Motor Company
THE PARK LEVER ON THE INVOLVED VEHICLES CONTAINS A DEFECTIVE SPRING WHICH COULD PREVENT AUTOMATIC ENGAGEMENT OF THE PARKING GEAR.
United States
Ford Motor Company
DURING A CRASH BARRIER TEST, THE RUBBER HOSE CONNECTING THE FUEL TANK AND THE METAL FILLER PIPE VENT TUBE WAS CUT, RESULTING IN FUEL LEAKAGE. THE INVOLVED VEHICLES FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.
United States
Ford Motor Company
UNDER CERTAIN TOLERANCE CONDITIONS, THE ACCELERATOR ROD MAY COME INTO CONTACT WITH THE ACCELERATOR RETURN SPRING BRACKET, CREATING THE POSSIBILITY OF A MOMENTARY DELAY IN THE RETURN OF THE ACCELERATOR LINKAGE TO THE IDLE POSITION. THIS CONDITION IS MORE LIKELY TO OCCUR AT 3/4 THROTTLE BECAUSE CLEARANCE BETWEEN THE…
United States
Ford Motor Company
THE REINFORCEMENT FOR THE IN-BOX SPARE TIRE CARRIER MAY HAVE BEEN ATTACHED USING INCORRECT HEX HEAD BOLTS. IF THE CARRIER AND REINFORCEMENT ATTACHING BOLTS ARE INCORRECT, THE POTENTIAL EXISTS FOR THE TIRE SIDEWALL TO BE DAMAGED OR WEAKENED BY EXTENDED CONTACT WITH THE SHARP EDGES OF THE BOLT HEADS.
United States