Ford

October 28, 1986

United States

Ford Motor Company

STEERING SHAFT ASSEMBLIES CONTAIN LOWER SHAFTS OF INSUFFICIENT LENGTH FOR PROPER ATTACHMENT TO THE SHAFT INSULATOR FLANGE. CONSEQUENCE OF DEFECT: SHAFT COULD SEPARATE, RESULTING IN TOTAL LOSS OF STEERING CONTROL AND A POSSIBLE ACCIDENT.

October 24, 1986

United States

Ford Motor Company

WIRING HARNESS IN THE ENGINE COMPARTMENT MAY BE MISROUTED AND SUBJECT TO DAMAGE. CONSEQUENCE OF DEFECT: A SHORT CIRCUIT COULD OCCUR (DURING USE OR WHEN PARKED) WHICH COULD RESULT IN A VEHICLE FIRE.

September 2, 1986

United States

Ford Motor Company

FUEL TANKS MAY HAVE BEEN SCORED OR PENETRATED WHEN FLOOR PAN MOUNTING HOLES FOR THE PARTITIONS WERE DRILLED. CONSEQUENCE OF DEFECT: FUEL LEAKAGE MAY OCCUR AND IN THE PRESENCE OF AN IGNITION SOURCE, THE POTENTIAL FOR A FIRE WOULD EXIST.

August 14, 1986

United States

Ford Motor Company

TRUCKS FAIL TO MEET REQUIREMENT OF FMVSS NO. 301, FUEL SYSTEM INTEGRITY, IN A 30 MPH FRONT ANGULAR BARRIER TEST IMPACT BECAUSE OF THE OMISSION OF THE NOSE SHIELD ON MIDSHIP FUEL TANK.

August 12, 1986

United States

Ford Motor Company

HAND THROTTLE CONTROLS WERE NOT IDENTIFIED EITHER ON THE CONTROL KNOB OR ON THE INSTRUMENT PANEL AS REQUIRED BY FMVSS 101. CONSEQUENCE OF DEFECT: TRUCKS ARE NOT IN COMPLIANCE WITH FMVSS 101, CONTROLS AND DISPLAYS.

August 8, 1986

United States

Ford Motor Company

UNDER CERTAIN CONDITIONS, CONTACTS IN BRAKE SYSTEM RELAY COULD REMAIN CLOSED, CAUSING THE BRAKE PUMP MOTOR TO RUN CONTINUOUSLY, CAUSING IT TO OVERHEAT AND EVENTUALLY FAIL. CONSEQUENCE OF DEFECT: SHOULD THE BRAKE SUPPLY MOTOR FAIL, THE POWER ASSIST TO THE FRONT BRAKES WILL BE LOST, AND AFTER ABOUT 10 TO 15 NORMAL… United States

Ford Motor Company

THE IGNITION LOCK CYLINDER MAY HANG UP AND NOT FULLY RETURN TO THE "ON" POSITION FROM THE "START" POSITION AFTER STARTING THE ENGINE. IF THIS OCCURS, THE ENGINE WILL REMAIN RUNNING, BUT THE BATTERY CURRENT TO THE BRAKE SYSTEM SUPPLY MOTOR WILL BE INTERRUPTED.

July 15, 1986

United States

Ford Motor Company

THE RUBBER THAT ENCASES BALL STUD AND SOCKET JOINT (CONNECTS STEERING DRAG LINK AND PITMAN ARM) MAY DETERIORATE, CAUSING METAL TO METAL CONTACT, AND MAY EVENTUALLY RESULT IN COMPLETE SEPARATION. CONSEQUENCE OF DEFECT: COMPLETE SEPARATION OF THE DRAG LINK TO PITMAN ARM CONNECTION RESULTS IN LOSS OF STEERING CONTROL…

July 14, 1986

United States

Ford Motor Company

COMPOSITE GRAPHITE DRIVESHAFTS ARE SUBJECT TO OVERHEATING WHILE IDLING, WHICH MAY RESULT IN THE DRIVESHAFT TWISTING AND SHORTENING CAUSING THE SLIP YOKE TO DISCONNECT FROM THE TRANSMISSION. CONSEQUENCE OF DEFECT: IF THE DRIVESHAFT DISCONNECTS FROM THE TRANSMISSION THE VEHICLE WOULD BECOME IMMOBILE WITHOUT WARNING.

July 11, 1986

United States

Ford Motor Company

BUSES MAY HAVE BEEN BUILT WITH AN INCORRECT TYPE OF STEEL TUBING IN THE INTERMEDIATE REAR SERVICE BRAKE LINES WHICH MAY LEAK OR BREAK DURING APPLICATION OF THE BRAKES. CONSEQUENCE OF DEFECT: IF A BRAKE LINE LEAKED, REAR BRAKES COULD QUIT WORKING, INCREASING STOPPING DISTANCE, WHICH COULD RESULT IN A CRASH.

June 24, 1986

United States

Ford Motor Company

THE FORWARD BOLT THAT PROVIDES PART OF THE ATTACHMENT BETWEEN THE DRIVER'S SEAT BACK ASSEMBLY AND THE SEAT CUSHION FRAME MAY BE SUBJECT TO FATIGUE FRACTURE. CONSEQUENCE OF DEFECT: IF THIS BOLT BREAKS, THE DRIVER AND SEAT BACK WILL FALL BACK, WHICH COULD RESULT IN THE DRIVER LOSING CONTROL OF THE CAR AND POSSIBLY LEAD…

May 21, 1986

United States

Ford Motor Company

HEADLAMP COVERS WERE INSTALLED ON VEHICLES IN ERROR. CAUSING THE CARS NOT TO COMPLY WITH FMVSS 108, LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT.

April 14, 1986

United States

Ford Motor Company

IMPROPERLY HEAT TREATED STEEL ROLLERS USED IN THE REAR WHEEL PARKING BRAKE SYSTEM CAUSES THE ROLLERS TO BECOME BRITTLE AND MAY FRACTURE. CONSEQUENCE OF DEFECT: ROLLERS COULD FRACTURE WHEN THE PARKING BRAKES ARE SET, RESULTING IN REDUCTION OR COMPLETE LOSS OF PARKING BRAKE HOLDING CAPABILITY, WHICH MAY LEAD TO AN…

March 27, 1986

United States

Ford Motor Company

THE OUTSIDE REAR VIEW MIRRORS DO NOT MEET THE 50 SQUARE INCH MINIMUM REQUIREMENT OF FMVSS 111-REARVIEW MIRRORS. CONSEQUENCE OF DEFECT: THE STANDARD REQUIRES A MINIMUM DIMENSION FOR REARVIEW MIRRORS TO PROVIDE ADEQUATE FIELD OF VISION WHICH AIDS IN PREVENTING ACCIDENTS.

March 10, 1986

United States

Ford Motor Company

THE RIGHT QUARTER WINDOWS MAY CONTAIN GLASS WHICH WAS IMPROPERLY TEMPERED. THIS GLASS MAY YIELD PIECES LARGER THAN THE MAXIMUM ALLOWED BY FMVSS 205, GLAZING MATERIAL.

February 10, 1986

United States

Ford Motor Company

WIRING CONNECTIONS IN AN ELECTRICAL CONNECTOR TO THE MASTER CYLINDER RESERVOIR FLUID LEVEL SENSORS WERE REVERSED AND FAIL TO INDICATE LOW FLUID LEVELS AS SPECIFIED BY FMVSS 105, HYDRAULIC BRAKE SYSTEMS. CONSEQUENCE OF DEFECT: SENSOR WILL NOT TRANSMIT SIGNAL TO BRAKE WARNING LIGHT WHEN THE FLUID LEVEL IS LESS THAN ONE…

January 22, 1986

United States

Ford Motor Company

THERE MAY BE INADEQUATE WELDING IN SOME UNDERBODY STRUCTURAL AREAS, INCLUDING THOSE AT THE REAR SUSPENSION ATTACHMENTS, WHICH MAY CAUSE IT TO SEPARATE. CONSEQUENCE OF DEFECT: IF REAR SUSPENSION ATTACHMENTS SHOULD SEPARATE FROM THE UNDERBODY DURING VEHICLE USE, THE AXLE COULD SHIFT DURING ACCELERATION OR BRAKING AND…

December 26, 1985

United States

Ford Motor Company

December 20, 1985

United States

Ford Motor Company

THE HYDRAULIC PARKING BRAKE CONTROL VALVE MAY INADVERTENTLY ACTIVATE DUE TO MOMENTARY PRESSURE DISRUPTIONS WITHIN THE SYSTEM AND CAUSE THE PARKING BRAKE TO BE APPLIED, STOPPING OR SLOWING THE TRUCK UNEXPECTEDLY. CONSEQUENCE OF DEFECT: THIS UNEXPECTED STOPPING OR SLOWING OF THE TRUCK MAY INCREASE THE RISK OF A REAR…

November 5, 1985

United States

Ford Motor Company

REAR SUPENSION CONTROL ARM-TO-SPINDLE ATTACHMENT BOLTS MAY BE SUBJECT TO FRACTURE CAUSING THE REAR SPINDLE TO SEPARATE DURING USE OF CAR. CONSEQUENCE OF DEFECT: IF BOLTS FRACTURE AND REAR SPINDLE DISENGAGES FROM CONTROL ARM, LOSS OF CONTROL WILL BE EXPERIENCE WHICH MAY RESULT IN AN ACCIDENT.