Battle

May 13, 2005

United States

Battle Motors, Inc.

CERTAIN MOBILE DRILL RIG CAB AND CHASSIS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, 'AIR BRAKE SYSTEMS.

February 4, 2005

United States

Battle Motors, Inc.

ON CERTAIN DRILL RIGS AND WELL SERVICE RIGS EQUIPPED WITH BENDIX ANTILOCK BRAKE SYSTEM (ABS), THE AIR BRAKE VALVING INSTALLED ON THE DRIVE AXLES OF CERTAIN TRI-DRIVE AXLE IS INADEQUATE AND IT DOES NOT HAVE THE CORRECT AIR VALVE CONFIGURATION FOR THE RAPID RELEASE AND REAPPLICATION OF AIR NECESSARY FOR THE ABS TO…

July 21, 2004

United States

Battle Motors, Inc.

CERTAIN TRUCKS EQUIPPED WITH NEXGEN LIQUID NATURAL GAS (LNG) TANKS ARE BEING RECALLED. THE INTRODUCTION OF WATER INTO THE DISCHARGE SIDE OF BOTH THE PRIMARY AND SECONDARY RELIEF VALVES SIMULTANEOUSLY AND SUBSEQUENT FREEZING IN SERVICE CAN RENDER THE VALVES TEMPORARILY INOPERATIVE.

May 6, 2004

United States

Battle Motors, Inc.

ON CERTAIN VEHICLES EQUIPPED WITH GALAXY DISC TRUCK WHEELS, SIZE 22. 5" X 9", A FAILURE OF THESE WHEELS CAN OCCUR.

July 9, 2003

United States

Battle Motors, Inc.

ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CUMMINS C8. 3G AND L10G ELECTRONIC CONTROL MODULES (ECM), THE ECM DOES NOT HAVE THE ABILITY TO DETECT A THROTTLE FAIL-SAFE ENGINE SHUTDOWN COMMAND.

May 15, 2003

United States

Battle Motors, Inc.

ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH CUMMINS WESTPORT B GAS PLUS OR C GAS PLUS 6 CYLINDER ENGINES, THE ELECTRONIC CONTROL MODULE CALIBRATION MAY NOT CORRECTLY DETECT A THROTTLE PLATE ACTUATOR FAILURE THAT COULD RESULT IN AN UNCOMMANDED OPEN THROTTLE CONDITION.

May 1, 2003

United States

Battle Motors, Inc.

ON CERTAIN TRAILERS EQUIPPED WITH A SPECIFIC COMBINATION OF REYCO SUSPENSION, EATON DRIVE AXLE, AND BENDIX SLACK ADJUSTERS, THE FAILURE OF A DRIVE AXLE SLACK ADJUSTER TO AUTOMATICALLY ADJUST AS REQUIRED TO COMPENSATE FOR BRAKE WEAR, WILL CAUSE AN OUT OF ADJUSTMENT CONDITION. IF THIS CONDITION OCCURS AND IS NOT…

September 5, 2002

United States

Battle Motors, Inc.

ON CERTAIN TAG AND PUSHER AXLE ASSEMBLIES PURCHASED FROM RIDEWELL, THE AXLE ASSEMBLIES HAVE AN ACTUAL WEIGHT RATING LESS THAN THAT SPECIFIED ON THE LABEL AND THEREFORE FAIL TO COMPLY WITH THE REQUIREMENTS OF PART 567. 5, "CERTIFICATION.

March 15, 2002

United States

Battle Motors, Inc.

ON CERTAIN VEHICLES EQUIPPED WITH TELEFLEX MORSE ELECTRIC FLOOR PEDALS. UNDER HEAVY USE, ONE OF THE PEDAL DUAL RETURN-SPRING ARMS ON THE FLOOR-MOUNTED ELECTRIC PEDALS MAY FAIL.

November 21, 2000

United States

Battle Motors, Inc.

VEHICLE DESCRIPTION: REFUSE TRUCKS. THE "PLATE, INSTRUCTION: "CAUTION" DISCONNECT FAN" DECAL INCORRECTLY STATES THE PROCEDURE TO ASSURE THE ENGINE COOLING FAN WILL NOT COME ON WHILE BEING SERVICES.

September 2, 1997

United States

Battle Motors, Inc.

VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY VEHICLES EQUIPPED WITH STEERING AXLE HUBS BUILT BY WEBB WHEEL FOR USE ON TRUCKS AND TRACTORS, PART NUMBERS WEBB 1530, VOLVO 90402-0006, OR EATON F1960. THE STEERING AXLE HUB FLANGE CAN FRACTURE AND SEPARATE FROM THE CENTER PORTION OF THE HUB.

February 3, 1997

United States

Battle Motors, Inc.

THE TRANSMISSION RANGE SELECTOR PAD WILL INDICATE A DRIVE RANGE WHEN THE TRANSMISSION IS ACTUALLY IN NEUTRAL.

August 26, 1993

United States

Battle Motors, Inc.

THE BOLT WHICH ATTACHES THE REAR SUSPENSION TORQUE ROD TO THE AXLE BRACKET RESTRICTS THE MOVEMENT OF THE OUTSIDE BRAKE PAD, RESULTING IN ONLY THE INSIDE BRAKE PAD CONTACTING THE ROTOR.

September 23, 1981

United States

Battle Motors, Inc.

THE SAWCUT SHOULD RUN ONLY HALFWAY THROUGH THE DRAGLINK SECTION. INSTEAD, IT RUNS THROUGH THE ENTIRE SECTION CAUSING INSUFFICIENT CLAMPING FORCE ON THE STEERING BALL SOCKET.

June 27, 1978

United States

Battle Motors, Inc.

THE ANTI-LOCK BRAKE SYSTEM FAILS TO COMPLY TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS".

January 31, 1974

United States

Battle Motors, Inc.

November 19, 1973

United States

Battle Motors, Inc.

January 29, 1973

United States

Battle Motors, Inc.

August 8, 1972

United States

Battle Motors, Inc.